QTH161 - 16 Channel 720P Analog HD DVR


QT Series – QTH161 Analog HD DVR

720P @30FPS, 960H @30FPS, H.264, 16 Channel, Analog HD, Scan N' View, Motion Detection



QTH161 - 4 Channel DVR spec sheet


How to Setup

QT Series Analog DVR Quick Start Guide


FAQ Top Answers

Motion Detection Setup

How to Adjust Motion Sensitivity and Configure Detection Areas

Scan N' View Setup for Local and Remote Access

Local Access Setup for Internet Explorer

How to Playback

How to Backup

Mobile Setup for Android

Mobile Setup for iOS


Trouble Shooting

QT Series DVR Manual

Password Configuration from the Wizard

How to Change your Password

DVR Audio Recording Setup

How to Change Camera Viewing Modes

Email Notification, Motion Detection, and Snapshots Setup



QT View for PC

QT View for OS X

IPTool for PC


Recovery Firmware (Only for NON Booting Systems)

CAUTION: Updating the firmware incorrectly or using an update on the wrong DVR can permanently damage the chip-set on the DVR and make it unusable. Please verify that this update is written for your model.

Firmware updates are released to resolve performance issues and/or to add features. Any update could fail and cause problems if the steps are not followed correctly, or if the update is not required.

If you are not experiencing an issue that the firmware update was written to resolve, or you do not need the feature that is added by the update, please do not run the update.

If you have any questions about updating your firmware, please contact technical support.  Q-See is not liable for systems damaged while updating the firmware.  Q-See recommends contacting technical support, before updating, to avoid damage to your system.




The QTH161 is compatible with ALL brands of Analog BNC cameras. Resolutions supported are D1 (702x480) and 960H (960x480).


ANALOG HD Compatibility Chart

How did we do?

Q-See (opens in a new tab)

Powered by HelpDocs (opens in a new tab)