QCN7006B Firmware Update
Step 2
Connect your Computer to one of the POE Ports on the back of your NVR.
Leave the camera(s) requiring an update connected to the NVR.

Step 3
The Downloads Folder will open on your PC.
Right-click QCN7006B-FW
Click Extract All...

Step 4
Click Extract

Step 5
Double Click General_ConfigTool_Eng

Step 6
Proceed with the installation of the ConfigTool.
Click Next

Step 7
Review and Agree with the License Agreement.
Click Install

Step 8
Click Enjoy Now

Step 9
ConfigTool will open automatically.
Click Setting

Step 10
☑ Search by IP domain

Step 11
Enter the Start IP as 10.1.1.1
Click OK

Step 12
Click Refresh
Make a note of the IP of your camera(s).

Step 13
Go back to the QCN7006B Firmware Files Folder.
Double-click RECUpgrade1.1.7.exe to open.

Step 14
The Upgrade Tool will open.
Enter the IP Address of your camera into the tool.

Step 15
Click Login

Step 16
Enter the Username: admin
Password: admin
Click OK

Step 17
Click Open files

Step 18
In the QCN7006B Firmware Folder:
Select QSee_IPC-HFW11XX...
Click Open

Step 19
Click Bios

Step 20
Once the update is completed, a window will appear.
Click OK

Step 21
Go back to the QCN7006B Firmware Folder:
Double-click the Clear Config Folder.

Step 22
Right-click clear_config_tool
Click Run as administrator

Step 23
Enter the IP Address of your camera.
Click GO

Step 24
Once the reset is completed, a message will appear below the progress bar.
Close the tool by clicking the X in the top right.
